products

> crash attenuators > Scorpion II® Truck Mounted Attenuator

Scorpion II® Truck Mounted Attenuator

The Scorpion II TMA from TrafFix Devices is the world's first MASH Tested, Passed, and Eligible Truck Mounted Attenuator. The Scorpion II Truck Mounted Attenuator is hydraulically powered and is ideal for stationary and mobile construction zones.

Weight    1,975 lbs (900 kg)

Length    Travel/Storage 2' 5" (.74 m)Deployed 12' 10" (3.93 m)

Width      8' (2.45 m)

Height     Travel/Storage 12' 5" (3.8 m)Deployed 12" ± 1" (305 mm ± 24.4 mm)

Specification

 

The Scorpion II Truck Mounted Attenuator (TMA) is a mobile crash cushion attached to the rear of a support vehicle’s frame. The TMA may be used on moving shadow trucks, stationary block vehicles, or advanced warning vehicles upstream of a moving or stationary operation. The TMA is tested, passed and eligible to MASH TL-3 (62.5 mph / 100 kph). The TMA can be used on support vehicles with a minimum actual/curb weight of 15,000 lbs (6,804 kg) with no upper weight limit (infinite weight). Lighting consists of LED brake, directional, signal and running lights for enhancement of advanced warning to drivers. The TL-3 TMA has an overall dimension of 12.94 ft. (3.9 m) × 8.0 ft (2.4 m) × 2.0 ft (0.6 m) and has a ground clearance of 12" ± 1" (305 mm ± 25.4 mm) when deployed in the horizontal operating position. The Scorpion II TMA consists of three (3) main components: Strut, Cartridge, and backup/diaphragm frames. The Strut and Cartridge are the energy attenuation components. The Strut is positioned nearest to the support vehicle and the Cartridge is positioned furthest away from the support vehicle. The Cartridge is typically the first component impacted by an errant vehicle. The Strut consists of four (4) outboard convex aluminum tubes (two on each side) forming an aluminum structural weldment. The aluminum structural weldments bolt to a structural steel diaphragm/backup frame. The TMA can be rotated in a double 90° fold position over the support vehicles bed with a stored height of less than 12’ 5” (3.8 m). An optional hydraulic powered vertical lift can be utilized with the TMA to deploy a display panel when the TMA is lowered into the use position. The vertical lift is powered by the same on-board hydraulic system that rotates the TMA into the travel/storage and deployed positions. The vertical lift is sequenced to raise and lower a panel for displaying advanced messages, directional indicators, or other notifications.

 

ROAD SAFETY LLC

129 Roesler Road

Glen Burnie, MD 21060

 

Phone:410-787-0222

Fax:410-787-1260

 

8am-4pm

Monday-Friday

 

©ROADSAFETY LLC 2018